![]() ![]() ![]() It isn't needed in the physical sense - you can just connect your programmer to these points in the circuit using temporary clips of some sort. Node_pix_only_v2.png still has an output A & B - there's just no Max485 which means it wont do DMX.The programming header is simply where you attach a programmer - usually a USB->UART dongle. Also realise that this code isn't tested at all so might need a bit of modification :) Don't forget to initialise the pin in the setup function as an output.Let me know how you get on. I'd recommend 0 as in DMX mode, there is only 0.desiredChannel is the DMX channel you'd like to use - remember these start are siredThreshold is where you'd like the relay to turn on - it's from 0-255desiredPin is the output pin. That shouldn't be too difficult if you just want it hard coded - adding it so it's configurable would be a bit more involved and I might look at it in the future.For a basic hard-coded fix, in dmxHandle() add something like the following into either the portA or port B if section:if (port = desiredPort) desiredPort is 0-3 and refers to which of the 4 ArtNet ports will be used. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |